Charlotte Waters Telegraph Station: a long low stone building on a bare rise
Alice Springs Telegraph Station: white buildings and stock yards below the ranges
The operating room of the Eucla telegraph station: a long bench of telegraph instruments under a clock
Barrow Creek Telegraph Station seen from the hill behind it, with plains to the horizon

Telegraph stations on the Overland Telegraph Line, about 1900. Every report they sent went by wire.

Wireless dash switches

Switches made for the spare blanks in your dash. Each one takes 12 V+ and earth from nearby and reports to the control box by radio. No cable run to the box.

Get launch news

How it goes in

  1. Clip it in

    Each switch clips into a spare 22 × 22 mm blank. Its own small module sits behind the dash on the switch’s wiring tail.

  2. Power and earth

    The module takes 12 V+ and earth from nearby, through one fused tap shared by all the switches. That is all the wiring at the dash.

  3. Pair it

    Pair the switch to the control box in the app and choose the output it runs. The setting is stored in the box, so it works with no phone in the car.

What it does

Press a switch on this dash, or pick a different icon for it. The light only comes on when the box says the output is on.

Output 1, light bar: on, as reported by the box.

A quiet switch can’t leave an output stuck on.

Settings live in the box, not the phone.

A red dirt road in outback Australia, corrugated by traffic, running straight to the horizon
Designed for corrugations: a latching connector and a tie-down point on every module.

2 wires

12 V+ and earth per switch. Nothing runs back to the box.

Three ways to work

  • Toggle. Press on, press off.
  • Momentary. On while you hold it.
  • Timer. Turns itself off.

Why Outstation

A lone pole of the old Overland Telegraph Line standing in long grass on red earth

An outstation is a remote post that reports to the main station. Each switch is one: it sits in its own blank and reports to the box in the rear, with no line between them.

Follow the build

Starting with the Prado 250

Outstation icon

The first kit is made to suit the Toyota Prado 250 and its square 22 × 22 mm blanks. We are measuring a real blank and sample switches before we promise a fit.

Tell me when it is ready
Register for launch news. This opens an email to us; send it and we will write once, when the kit is ready to order. Register